Link speed and duplex settings
This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed and communication mode of the print server must match the network hub. For most
situations, leave the product in automatic mode. Incorrect changes to the link speed and duplex settings
might prevent the product from communicating with other network devices. If you need to make changes,
use the product control panel.
The setting must match with the network product to which you are connecting (a network hub,
switch, gateway, router, or computer).
Making changes to these settings causes the product to turn off and then on. Make changes only
when the product is idle.
From the Home screen on the product control panel, touch the Setup button.
Scroll to and touch the
Select one of the following options.
The print server automatically configures itself for the highest link speed and
communication mode allowed on the network.
10 Mbps, full-duplex operation
10 megabytes per second (Mbps), half-duplex operation
100 Mbps, full-duplex operation
100 Mbps, half-duplex operation
button. The product turns off and then on.
Configure IP network settings 129